Hood Adjuster 51767183752

Ensure perfect hood alignment and soft, rattle-free closure with the genuine hood adjuster (part 51767183752). Also known as the hood bumper stop buffer, this durable rubber-tipped adjuster installs at both front corners of the hood to fine-tune panel gaps and absorb impact when closing.

Key Benefits

• Exact OEM Fit
  Machined to BMW’s original specifications for seamless installation at left and right front hood mounts without modifications.

• Adjustable Rubber Buffer
  Threaded body allows 5 mm of precise height adjustment to match factory gap tolerances and prevent hood misalignment.

• Impact Absorption
  Nitrile-rubber tip dampens closure shock and reduces noise, protecting paint and hood edge from damage.

• Durable Construction
  Zinc-plated steel shaft with heat- and UV-resistant rubber tip withstands repeated cycles and environmental exposure.

Vehicle Compatibility

Fits a wide range of BMW vehicles equipped with hood bumper stops, including most 2011 → 2024 models across 1, 2, 3, 4, 5, 6, 7, 8 Series, X Series, Z4 and more. Always verify via VIN or on-vehicle part stamp to ensure exact match.

Technical Specifications

1. Open the hood and locate the factory bumper stop holes at each front corner.

2. Remove any existing bumper stop by turning the locknut counter-clockwise.

3. Insert the new adjuster’s shaft through the hood mount; hand-thread the locknut on the underside.

4. Adjust the rubber tip height until the hood closes evenly without gaps.

5. Tighten the locknut to secure the setting, then test hood operation for smooth, silent closure.