Front-left wiper linkage bracket
Bring back factory-smooth windscreen wiping with the genuine front-left wiper linkage bracket (OEM part number 1933691 / BM51-17K484-AC). Pressed from high-strength, zinc-coated steel, this mount secures the pivot arm and motor drive on the driver’s-side scuttle panel, eliminating play that causes judder, noise or incomplete wipe patterns.
Ford Focus Front-Left Wiper Linkage Bracket 1933691
Bring back factory-smooth windscreen wiping with the genuine front-left wiper linkage bracket (OEM part number 1933691 / BM51-17K484-AC). Pressed from high-strength, zinc-coated steel, this mount secures the pivot arm and motor drive on the driver’s-side scuttle panel, eliminating play that causes judder, noise or incomplete wipe patterns.
Key Benefits
-
Exact OEM geometry – locator pins, M6 bolt holes and nylon-lined pivot seat line up perfectly with the original wiper assembly; no drilling or shimming required.
-
Galvanised finish – corrosion-resistant coating protects against road salt and acidic washer fluid for long service life.
-
Pre-installed bushings – factory-pressed composite bearings provide low-friction movement and damp vibration at the wiper arm.
-
Weather-sealed grommet – integrated EPDM grommet keeps water out of the bulkhead and wiring cavity.
-
Two-year Ford parts warranty – full dealership backing for complete peace-of-mind.
Vehicle Compatibility
| Model | Chassis | Years | Position |
|---|---|---|---|
| Ford Focus Mk III | C346 (hatch, estate, saloon) | 2011 → 2018 | Front left (driver-side on LHD) |
Technical Specifications
| Specification | Detail |
|---|---|
| OEM part no. | 1933691 / BM51-17K484-AC |
| Material | Galvanised high-strength steel |
| Finish | Clear zinc with anticorrosion lacquer |
| Pivot bearing | Nylon-composite, pre-lubricated |
| Fastening | Re-uses OE M6 Torx screws |
| Weight | ≈ 340 g |
| Warranty | 24 months, unlimited mileage |
-
Disconnect the battery and lift the wiper arms off the screen.
-
Remove the plastic scuttle panel and unscrew the old bracket (two M6 Torx).
-
Unclip the linkage rod from the worn bracket; support the wiper motor.
-
Position the new mount, engage the linkage ball joint and hand-thread the bolts.
-
Torque fasteners to 10 Nm; refit scuttle panel and wiper arms.
-
Test washer and wipe cycles—blades should sweep smoothly and quietly.
Specifikācija nav atrodama